Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current Restore this Version View Page History

« Previous Version 3 Next »

Overview

To start the default runtime use the following command:

java -jar server.jar

A single-VM instance will be created using the configuration specified in runtimes/vm. Alternative configurations can be used by specifying the runtime name as shown below. The runtime name will map to a configuration contained under the runtimes directory:

java -jar server.jar controller  -- launches a runtime using the configuration under runtimes/controller 
java -jar server.jar participant -- launches a runtime using the configuration under runtimes/participant  
java -jar server.jar foo -- launches a custom runtime using the configuration under runtimes/foo image

Note it is possible to run multiple runtime instances from a single disk image. In this case, the image will contain multiple configurations under the runtimes directory. Each instance can then be started by specifying the runtime name, for example:

java -jar server.jar foo
java -jar server.jar foo2

Startup Parameters

Clean

The clean parameter clears runtime state and removes any persisted information from previous runs. To start the runtime in clean mode, use the clean parameter:

java -jar server.jar clean

Note starting the runtime in clean mode will delete information stored in the data directory, including transaction recovery logs. 

Clone

The clone parameter makes a copy of a runtime configuration template and boots the runtime using the copied configuration:

java -jar server.jar clone:template1 runtime1

Dir

The dir parameter is used to specify an alternative directory for the runtime configuration:

java -jar server.jar dir:/usr/fabric3/config/runtime1